Pro2go - Fasteners

The old way of doing things was a ballet of frustration: carry a heavy impact driver, a box of loose bolts, a separate box of washers, and a separate box of nuts. You’d climb a ladder with your knees pinching a driver, a bolt in your teeth, and a prayer in your heart. You’d drop the washer. It would roll into the mud. You’d strip the cheap threads. You’d curse. The sun would rise higher, and the deadline would get closer.

Mike just grabbed the Pro2Go driver. He didn’t need two hands to juggle parts. He pressed the nose of the driver against the steel. BRRRRT. In one fluid second, the Pro2Go punched through the metal shavings, aligned itself with the backer, and seated the washer with a satisfying thwump . pro2go fasteners

Today, however, Mike reached into his vest pocket. He pulled out a strip of ten Pro2Go fasteners. They looked like a plastic bullet belt from a sci-fi movie. Each unit was a single, cohesive piece: a sharp-pointed screw, a bonded neoprene washer, and a precision-engineered thread, all held in perfect alignment by a dissolvable polymer carrier. The old way of doing things was a

Mike stepped back. The beam was secure. No loose washer rattling in the dirt. No stripped thread. The dissolvable carrier that held the strip together had cracked away cleanly, leaving only the perfect fastener embedded in the steel. It would roll into the mud

Mike nodded.

He did it again. And again.

The building inspector showed up early. He ran a gloved finger over a seam. “Pro2Go?” he asked.